Bathroom tile and flooring throughout San Diego County

Pricing isn't something Pro Bath SD handles. After taking measurements of the bathroom, the materials, and the permit route, the independent remodeler provides the quote. Line up written scopes side by side. A published dollar range isn't a local quote, so don't treat it as one. Usually the cost shifts based on wet-area square footage, tile, glass, and whether plumbing or electrical gets moved.

A retile of just the floor, with the right substrate prep, takes 2-4 days. A full shower, walls and floor included with waterproofing, runs 5-10 days on site. Heated floors add a day for the mat install plus a separate wall-control rough-in. Tile has to set 24-48 hours before grout goes in, and grout cures 24-72 hours before the shower gets used.

For San Diego bathrooms, porcelain is the go-to: dense, low-porosity, slip-resistant when textured, and rated for wet areas. Big porcelain formats (12x24, 24x24) give a modern look and mean fewer grout lines. Marble or travertine brings real beauty, but in hard-water zones it wants annual sealing and gentler cleaning.

Correct. Tile and grout alone don't stop water. You need a real waterproofing system behind them, either a PVC liner in a traditional mud pan or Schluter Kerdi membrane over Kerdi-Board or DITRA. San Diego inspectors won't pass a shower unless they can see a waterproofing layer. The independent remodeler always puts down sheet membrane or liquid-applied RedGard over cement board.

In most San Diego bathrooms, yes. The independent remodeler puts an electric radiant mat (Nuheat, Schluter DITRA-HEAT, or SunTouch) in the layer between the subfloor and the tile. That mat runs on its own GFCI circuit and is run by a wall control inside the room. Expect the electrician to add 1-2 days to the tile schedule, plus another 1-2 days for the electrical rough-in and trim.